Edmonton Electrician | Sinking Into A Hot Tub


Contact Info

Our Office

14927-69ST NW
Edmonton, Alberta


Regular Hours

M-F: 7am – 4:30pm
Evenings, Weekends & Holidays by appointment.


Emergency Service

Emergency fees apply

Get in Touch

(780) 935-0622

Edmonton Electrician | Sinking Into A Hot Tub

Likely, you should watch out, says Edmonton electrician! There are a lot of codes that you need to adhere to. And though you want to. Test your knowledge and process.
Edmonton Electrician

Of installing a hot tub by yourself. It is definitely not recommended. And you should bow to a lot of the professionals. The affectional electricians on the whole will have the.

Know-how and experience, much like. The fact that, says Edmonton electrician. They on average install a hotdog once a week in the summer. And once a month in the winter.

They are certainly going to watch out for the different. Rated cables that we need. And are going to have to do. The excavation if indeed you’re cables run underground.

However, that is going to be very labour-intensive. And you might not have the know-how to do it. Trust the professionals so that you are not going to look.

At your hot tub as a means. Of stress, and sinking a lot of money. Into mistakes that you have made. Ideally, watch out for the impassively. As hot tubs are going to use.

A lot of power on your grid. You may indeed need bigger cable. And a bigger breaker system, which is also going to need. To install by a master electrician.

There is to be a lot more code compliance as well. When you start to switch out. Old electrical pieces of equipment. For brand-new, bigger, and state-of-the-art pieces.

Read More…

Therefore, if you do it yourself. Without the know-how and knowledge of the codes. Then, by virtue of being lawful. You are going to need an inspection.

If that inspection has not been passes. Then you are going to. At your own cost and time wastage. Need to do it all again. Until you get the seal of approval.

From the provincial inspector. One of the things that are often going to be missed. Which is a very elementary consideration. Is if you have a hot tub that is rated for 105°C.

Then you have to use cable that is also rated for 105°C. The professional electrician will notice that from the beginning. And properly make sure that the cable has been installed.

If the inspection passes. Then you’re just not going. To be able to use your new hot tub. However, once the installation and connection has been done.

Four your new hot tub, inspections are going to be booked. And that can is by Hauer power. It is going to be a two-step process. The first process being bringing.

In all of the electrical wiring and such. As well as bringing in a whip. The phase 2 of the connection process. Is just the actual process of connecting all of the cables.

That is going to be paramount when people are going to use an old Connecture to a new connector. That is going to be a fire hazard and a health hazard.

The do-it-yourself installation, says Edmonton electrician. Is not recommending by most electricians. As they have seen it all, and. Know-how to troubleshoot any problem.

Edmonton Electrician | You Are Sunk In A Hot Tub

Edmonton electrician points to a GFCI, also known as a ground fault circuit interrupter. That, assuming that you’re going to install your new hot to. All by yourself.

You are going to need. To become aware of and make sure that it works. Indeed, there are going to be function tests for GFCI’s. And they are done all the time.

As a means to ascertain safety. And make sure that all of the safety protocols have been put in place. This is crucial so that you. Understand that the codes are in place.

For a very distinct and specific reason. That is to make sure that everybody is safe. And not wound to electrocution. Which, if not connected properly. Can lead to ultimate death.

Edmonton electrician also recognizes that some hot tubs. Are going to be rated for a certain temperature. Therefore, you are going to need. That cable that is also.

Rated for that particular cable. If you have cable that is rated for. A temperature colder than that of the hot tub. That is going to become a safety concern.

Your electrician states to watch out for. That capacity, as it should be known. That hot tubs do indeed use a lot of power. Often times, bigger cable will need to be installed.

As well as a bigger breaker system. To be needed in order to. Properly use the bigger amount of power. Code compliance is going to be crucial. In adhering to the process.

Read More…

Put forth by the province and the country. So that nobody is going to get electrocuted. For example, if you are using a tech 90 cable for a hot of that. Has been rated and is.

Going to be used at its capacity. Of 105°C, then that. Is going to cause ample problems. And will potentially need a reinstallation. At the owners cost and absolute stress.

You are not going to be able to pass the installation inspection. Which is then going to require you. To uproot all of the prior work. In a nutshell, it’s better safe than dead.

Edmonton electrician also wants people to understand. That you should be asking a lot of questions of the salespeople. From within the store that you’re buying the hot tub.

Buy a high quality hot tub. And if you need recommendations. The expert team at Hauer Power has. Many recommendations for you. To ensure what you buy. Can withstand the temperature changes. That the province of Alberta sees.

And that is going to be. A very big problem. Potentially for a lot of hot tub owners. If it is not properly installs. Because of the fact that. On average, 6000 wants is average.

For the range load that is being used in a home. This is going to have a very high draw capacity and. If you are drawing more than you are rated for. From within the home.

Then it is going to be such. Where you are going to. See a lot of breaker fails and even worse. There are potentially going to be a lot of health problems. And potential death and injury.

Contact Us

14927 69 St NW, Edmonton, AB T5C 0J3